Useful Information

"OSHA Regulation Inforcement"

The New CAL/OSHA Heat Illness Prevention Standard, Title 8, California Code of Regulations, Section 3395, adopted on June 15, 2005, requires all employers with outdoor worksites to provide enough fresh water and cool potable water so that each employee can drink at least 1 quart per hour.

Frequent conversations with CAL/OSHA indicate that this law will be a, "Key Inspection Point" during the upcoming year.

Feb 17, 2007

WARRANTY INFORMATION

Preventative Maintenance

for the Water Pro Hydration System

Models H-1, P-1, P-2, and M-1

A&E Safety and Development, LLC strongly recommends performing regular maintenance on your Water Pro Hydration Unit. Without regular scheduled maintenance, normal wear and tear may cause cumulative effects, such as misalignment or premature wear. This may result in downtime for the unit. For this reason we highly recommend following the maintenance schedules. Additionally, unusual symptoms should be reported to A&E Safety and Development, LLC at 818-365-1201.

DAILY MAINTENANCE:

• Unplug Battery if P-1, P-2, or M-1 model.
• Turn off, and disconnect hose if H-1 model.
• Inspect the unit for abnormal wear and tear.
• Remove accumulations of dust, dirt, and other substances by using a soft cloth and a non abrasive liquid cleaner. Wipe down entire exterior of unit (including frame, cage, copper tubing, cart handle, valves, hoses, rims, exterior water container, and exterior battery/pump casing. Note: DO NOT spray the cleaner into the water container if using the P-1, P-2, or M-1 models. Only use approved cleaner sold by A&E Safety and Development to clean the inside of any water containers stated. To clean the inside of the systems refer to the appropriate Water Pro Cleaning Systems, approved for cleaning of your specific unit.
• Dry off the unit after every use with a soft dry cloth.
• Inspect the battery attachment wires.
• Inspect the pump line/clamps for proper fit.
• Inspect valves for any abnormalities.
• Inspect hoses for any abnormalities.
• Charge and condition the battery.

WEEKLY MAINTENANCE:

• Unplug Battery if P-1, P-2, or M-1 model.
• Turn off, and disconnect hose if H-1 model.
• Check Air pressure in all tires.
• Check tightness of hose coupling entering the copper tube.
• Lubricate the axle/wheel area.
• Lubricate cart handle hinge.
• Check the valves for tightness.
• Check cage for distress.
• Check frame for miss-alignment.
• Check external screws for tightness.
• Check tightness of tire lug-nuts.
• Check tightness of axle bolt on tire rim.
• Check on-off switch for wear.

MONTHLY MAINTENANCE:

• Unplug Battery if P-1, P-2, or M-1 model.
• Turn off, and disconnect hose if H-1 model.
• Inspect for advancement of any conditions that may cause deterioration of unit.
• Thoroughly clean entire unit with soft dry cloth and a non abrasive liquid cleaner.
• Thoroughly dry after cleaning.
• Tighten chassis bolts.
• Lubricate all cage hinges.
• Lubricate all chassis parts.